邮轮船型发展趋势及对我国邮轮设计建造的思考

doi:10.19423/j.cnki.31-1561/u.2024.01.003

船舶 ›› 2024, Vol. 35 ›› Issue (01): 26-40.DOI: 10.19423/j.cnki.31-1561/u.2024.01.003

邮轮船型发展趋势及对我国邮轮设计建造的思考

马网扣

中船邮轮科技发展有限公司上海 200137

收稿日期:2023-12-15 修回日期:2024-01-16 出版日期:2024-02-25 发布日期:2024-03-01
作者简介:马网扣（1978-）,男,硕士,研究员。研究方向：邮轮总体研发设计。
基金资助:
上海市战略性新兴产业重大项目“十五万总吨级邮轮自主知识产权船型开发与核心系统研制工程”（YLKY-2023-5）

Development of Cruise Ship and Reflections on Its Design and Construction in China

MA Wangkou

CSSC Cruise Technology Development Co., Ltd., Shanghai 200137, China

Received:2023-12-15 Revised:2024-01-16 Online:2024-02-25 Published:2024-03-01

摘要/Abstract

摘要： 邮轮是典型的高技术、高难度、高附加值船型,是我国大力发展邮轮产业的载体和核心,但也是我国目前唯一不完全具备自主研发设计、建造、配套和运营能力的船型。文章首先回顾了国内外邮轮运营市场和新造船近况,总结了邮轮新造船的船型特点及发展趋势;然后介绍了甲醇动力邮轮、基于轻型材料的结构轻量化设计、基于有机朗肯循环的主机余热回收这3个潜力技术方向;最后从自主设计、高效建造及工程管控、自主配套及供应链建设、自主运营这4个方面,分析探讨了我国发展邮轮设计建造将面临的挑战和应对路径。

关键词: 邮轮, 发展趋势, 自主设计, 高效建造, 自主配套, 自主运营

Abstract: A cruise ship is a typical ship type of high technology, high difficulty, and high added value, which is the carrier and core of the rapid development of the cruise industry in China. However, it is also the only ship type that does not fully possess independent research and development, design, construction, supporting facility and operation capability in China. Firstly, the recent operation market and new shipbuilding industry for the cruise ship at home and abroad are reviewed. The ship type characteristics and the development of the newly-built cruise ships are then summarized. Three potential technologies are subsequently introduced, including methanol powered cruise ships, lightweight design based on lightweight materials and waste heat recovery of main engines based on Organic Rankine Cycle system. Finally, the challenges and countermeasures faced by the development of the design and construction of the cruise ships in China are analyzed and discussed from four aspects, namely independent design, efficient construction and engineering control, independent supporting facility and supply chain construction, and independent operation.

Key words: cruise ship, development tendency, independent design, efficient construction, independent supporting facility, independent operation

中图分类号:

U674.11

马网扣. 邮轮船型发展趋势及对我国邮轮设计建造的思考[J]. 船舶, 2024, 35(01): 26-40.

MA Wangkou. Development of Cruise Ship and Reflections on Its Design and Construction in China[J]. Ship & Boat, 2024, 35(01): 26-40.

参考文献

[1] 马网扣,黄昊,刘晓琼. 邮轮总体设计技术基础[M].哈尔滨:哈尔滨工程大学出版社, 2022.
[2] Cruise Lines International Association. State of the cruise industry 2023[R]. 2023.
[3] 中国海洋装备工程科技发展战略研究院.中国海洋装备发展报告(2023)[R].上海:上海交通大学出版社, 2023.
[4] Cruise Industry News.Global cruise ship orderbook special report[R]. 2023.
[5] 马网扣,黄雪忠,杨陆峰. LNG动力邮轮研发动向[J].中国船检, 2021(9):66-70.
[6] 张振振,陈晨,冯涛,等.南极旅游的发展和对我国的建议[J].海洋开发与管理, 2019, 36(6):59-62.
[7] 交通运输部,发展改革委,工业和信息化部,等.交通运输部等部门关于促进我国邮轮经济发展的若干意见[S]. 2018.
[8] 李彦庆. 绿色低碳对海事工业发展的影响[J].船舶, 2023, 34(4):1-18.
[9] 甘少炜,雷伟,周国强.甲醇:未来船用燃料[J].中国船检, 2016(8):90-94.
[10] 王思佳. 为什么是甲醇?[J].中国船检, 2022(1):38-42.
[11] 宋鹏飞,张超,肖立,等.海上风电非上网消纳及制醇氨技术综述[J]. 中外能源, 2023, 28(11):16-23.
[12] 冯利军,程正冲,李伏. 船用复合材料应用现状及发展[J].装备环境工程, 2017, 14(5):51-55.
[13] 汪璇,裴轶群,周方宇,等. 船舶复合材料应用现状及发展趋势[J].造船技术, 2021, 49(4):74-80.
[14] 李晓文,朱兆一,李妍,等.复合材料-金属混合船舶极限强度研究综述[J].船舶力学, 2020, 24(5):681-692.
[15] KONSTANTINOS G.Hull construction with composite materials for ships over 100m in length[D]. Cambridge: Massachusetts Institute of Technology, 2002.
[16] HERTZBERG T.LASS: lightweight construction applications at sea[R]. Gothenburg: SP Technical Research Institute of Sweden, 2009.
[17] FRANZ E, TOMMY H, MICHAEL R.LASS-C: lightweight construction of a cruise vessel[R]. Gothenburg: SP Technical Research Institute of Sweden, 2011.
[18] SONG J, SONG Y, GU C W.Thermodynamic analysis and performance optimization of an organic Rankine cycle(ORC)waste heat recovery system for marine diesel engines[J]. Energy, 2015, 82(1):976-985.
[19] VARSHIL P, DESHMUKH D.A comprehensive review of waste heat recovery from a diesel engine using organic rankine cycle[J]. Energy Reports, 2021, 7(6):3951-3970.
[20] 闫静文,杨柯峰,侯佳,等.有机朗肯循环膨胀机的研究进展和应用现状[J].热力发电, 2019, 48(7):10-18.
[21] 张昌远,徐斌,毛静,等. 内燃机余热回收有机朗肯循环系统研究综述[J].低温/制冷技术, 2021, 49(7):84-90.
[22] FREDRIK A, MARIA E M, MAGNUS G, et al.Waste heat recovery in a cruise vessel in the Baltic sea by using an organic Rankine cycle: a case study[J]. Journal of Engineering for Gas Turbines & Power, 2016, 138(1):1-10.
[23] 工业和信息化部, 发展改革委, 财政部, 等. 关于加快邮轮游艇装备及产业发展的实施意见[S]. 2022.
[24] 汪建华. 客滚船设计建造工作的思考与若干建议[J].船舶工程, 2023, 45(9):14-20.
[25] 翁雨波. 国外邮轮建造供应链管理启示[J]. 中国船检, 2019(3):50-52.
[26] 刘萧. 三菱重工转身[J]. 中国船检, 2016(12):40-43.
[27] 崔慧玲. 中国邮轮旅游十年发展历程回顾及展望[J].广西经济干部管理学院学报, 2017, 29(3):71-78.

编辑推荐

Metrics

联系电话：（021）63161688-105006
传真：（021）63151255
E-mail：chuanbo@maric.com.cn

邮轮船型发展趋势及对我国邮轮设计建造的思考

Development of Cruise Ship and Reflections on Its Design and Construction in China

PDF

可视化

摘要/Abstract

引用本文

使用本文

参考文献

相关文章 15

编辑推荐

Metrics

[1]	程帅, 孟祥慧, 吕步高, 李瑞, 于学超. 面向大型邮轮定制的模块化产品族设计方法研究[J]. 船舶, 2024, 35(01): 41-49.
[2]	陶志超, 杨瑜, 王露. 邮轮客舱智能调光控制方案[J]. 船舶, 2024, 35(01): 50-58.
[3]	许维明, 瞿荣泽, 薛国良, 徐敏义, 祝晓, 刘志坚, 张奇奇. 智能船舶系统研究现状及发展趋势[J]. 船舶, 2023, 34(04): 46-55.
[4]	胡方珍. 船舶行业国际标准化现状及发展建议[J]. 船舶, 2023, 34(02): 33-42.
[5]	于志同, 黄彦, 胡洛佳, 马蓉, 肖鹏, 程晓. 面向极地航运的卫星观测技术发展研究[J]. 船舶, 2023, 34(01): 12-19.
[6]	张海彬. 深水钻探装备技术发展现状及展望[J]. 船舶, 2022, 33(02): 1-12.
[7]	曹亚冬. 提高大型邮轮应急电网系统安全可靠性的设计分析[J]. 船舶, 2021, 32(06): 75-80.
[8]	徐耕读, 甘进, 吴卫国. 中型邮轮典型异型结构特点分析[J]. 船舶, 2021, 32(05): 33-39.
[9]	王树信, 王玉国, 彭佳杰, 林睿, 陈勇. 船舶制冷剂应用现状与发展趋势[J]. 船舶, 2021, 32(04): 55-62.
[10]	李鹏飞, 杨薛航, 吴兆年, 李闯. 基于LR规范的豪华邮轮全船有限元分析流程及应用[J]. 船舶, 2021, 32(01): 101-110.
[11]	林永水, 孔祥韶, 郭国虎, 胡灏天, 任鹏良, 王卓, 吴卫国. 大型邮轮上层建筑特殊结构强度分析[J]. 船舶, 2020, 31(05): 25-31.
[12]	曾国咏, 郭烨, 张威. DP-3钻井船应急关断系统自主设计[J]. 船舶, 2019, 30(06): 89-92.
[13]	黄嵘;祖成弟;刘志兵;. 满足智能船舶的动力系统发展浅析[J]. 船舶, 2018, 29(S1): 106-110.
[14]	李岩;黄磊;. 从东方红系列科考船沿革浅析海洋科考船的发展趋势[J]. 船舶, 2017, 28(S1): 24-27.
[15]	. MARIC首次承担技术责任的调距桨桨叶自主设计获得成功[J]. 船舶, 2017, 28(01): 83-.